Skip to content

Leave encashment and gratuity: how to calculate both

The gratuity formula (15/26 x last drawn basic x completed years, capped at Rs 20 lakh), eligibility rules, and how leave encashment is calculated, with worked examples.

Saralix Team5 min read
On this page

When an employee leaves, two items often cause arguments in the full and final settlement: gratuity and leave encashment. Both are formulaic, but each has rules about eligibility, wages and tax that are easy to get wrong. This post sets out the calculations with worked examples so HR and payroll can check each other’s numbers.

The rules described here are based on the Payment of Gratuity Act, 1972 and the Income-tax provisions as we understand them at the time of writing. The labour codes are being phased in and may change definitions such as “wages”. Verify against current law and your company policy before paying anyone.

Gratuity

Gratuity is a lump sum paid by the employer in recognition of long service. It is a statutory entitlement where the Payment of Gratuity Act applies, which in general means establishments with ten or more employees.

Eligibility

An employee is entitled to gratuity when they leave after five years of continuous service, on:

  • superannuation,
  • retirement,
  • resignation,
  • or death or disablement due to accident or disease, where the five-year condition does not apply.

In practice, payroll teams use 4 years and 240 days as the eligibility cut-off. The Act’s definition of continuous service treats 240 days worked in a year as a full year of service, so an employee with four full years and 240 days in the fifth has met the condition. If your establishment follows a different rule, such as for seasonal work, apply that.

The formula

For establishments covered by the Act:

Gratuity = (15 / 26) x last drawn monthly wages x completed years of service

Points to apply carefully:

  • Wages means basic salary plus dearness allowance. Do not include HRA, bonus or other allowances unless your policy says so. The new labour codes change how wages are defined, so check which rules your company is following.
  • Last drawn means the wages at the time of leaving, not the average of the year.
  • Completed years: a part of a year above six months is rounded up to the next year. Six months or less is ignored.
  • The divisor 26 reflects 26 working days in a month, and the 15 is days of wages per year of service.
  • Cap: the maximum gratuity is Rs 20 lakh for employees covered by the Act. Companies can pay more under their own scheme, but the excess is treated differently for tax.

Worked example 1

An employee has last drawn basic of Rs 40,000 and dearness allowance of nil. Their service is 7 years and 8 months.

  • Completed years: 7 years, plus 8 months which is more than six, so rounded up to 8 years.
  • Gratuity = 15 / 26 x 40,000 x 8 = Rs 1,84,615 (rounded to the nearest rupee).

Worked example 2: the cap

An employee with last drawn basic of Rs 3,00,000 and 20 years of service.

  • 15 / 26 x 3,00,000 x 20 = Rs 34,61,538.
  • The Act caps the payment at Rs 20,00,000, so the statutory gratuity is Rs 20 lakh.

Tax on gratuity

For employees covered by the Act, gratuity received on retirement, resignation or death is generally exempt from tax up to the least of the amount actually received, the formula amount, and Rs 20 lakh. Any gratuity above the exempt limit is taxable as salary, and it should be included in the final tax computation.

Provisioning

Since gratuity is a liability that builds up each year, companies should provide for it monthly or annually. Many small employers do not, and then face a large unplanned payout. A year-wise estimate based on current basic pay and service is enough to start; an actuarial valuation is needed for audited accounts.

Leave encashment

Leave encashment is the payment for unused leave, either during service or at exit. Unlike gratuity, it is mostly a matter of company policy, with the law setting only the broad framework (for example, the Factories Act and state shops and establishments laws specify minimum leave).

What your policy has to define

  • Which leave types are encashable. Earned or privilege leave usually is; casual and sick leave usually are not.
  • Carry-forward limits and what happens above them.
  • When it can be encashed: at exit, at year-end, or on request during the year.
  • The daily rate.

Calculating the daily rate

A common formula is:

Encashment = (monthly basic, or basic + DA) / 26 x number of days encashed

Some employers divide by 30 or by the number of days in the month, and some use gross pay. Any of these can be valid, but you should choose one, write it down and apply it to everyone. Using 26 gives a higher rate than 30, which matters over large balances.

Worked example 3

An employee leaves with 18 days of encashable earned leave. Basic salary is Rs 52,000.

  • Daily rate = 52,000 / 26 = Rs 2,000.
  • Encashment = 18 x 2,000 = Rs 36,000.

Tax on leave encashment

  • During service, encashment is taxable as salary and subject to TDS in that month.
  • At retirement or resignation, the exemption for non-government employees is limited by several caps: the actual amount received, ten months’ average salary, the leave entitlement at 30 days per year of service less leave already availed or encashed, and an overall cap of Rs 25 lakh. The balance is taxable.

Because these limits interact, the taxable part should be computed in the full and final settlement, not left to the employee to work out.

Putting it in the full and final settlement

A full and final statement normally has these lines:

  1. Salary for days worked in the last month.
  2. Leave encashment.
  3. Gratuity, if eligible.
  4. Bonus or incentive due.
  5. Reimbursements pending.
  6. Less: notice-period shortfall, loan balance, asset recoveries, and other dues.
  7. Less: TDS on the taxable part.

Check each line against the policy and the letter of appointment. Where an employee is entitled to gratuity, it is a legal liability and must be paid within 30 days of it becoming payable, or interest can apply.

How software handles it

In Saralix, the exit workflow computes gratuity after 4 years and 240 days using 15/26 x basic x completed years, rounds part years over six months up, and caps the result at Rs 20 lakh. Earned leave encashment is computed at basic / 26 a day, with an override per leave type, and the settlement shows the taxable portion. Maker-checker approval means a second person reviews the figures before payment. Whatever tool you use, keep the formula and the policy together in writing, so the next settlement is an exercise in arithmetic, not argument.

Free up to 10 employees

Run your first payroll free.

Attendance, leave, payroll and PF, ESI, PT and TDS compliance in one place. See the plans, or ask for a walkthrough.